| From: | "Aahz." <ErickKilmer-at-comcast.net> |
| Subject: | Re: Phil's Tank... and drill bits [TANKS [TANKS] |
| Date: | Mon, 06 Aug 2007 16:08:52 -0700 |
| Reply-To: | tanks-at-rctankcombat.com |
kevin harden wrote:
> their are two types of drill bits one will chip and the other will
> cut, it all depends on the way a drill bit has been sharpened ? but
> all 1mm 2mm 3mm drill bits should drill at high speed so i was tort
Smaller diameter usually results in higher speed depending on
composition of the drill and the material you're cutting.
Aahz.