RE: Tank turret wires. [TANKS]

["Martin Helsing" <martin.helsing-at-earthlink.net>]

When you have a new receiver, you have to bind the tx and rx …. Not sure if that will unbind the 1^st rx.

 

At $80 a pop, I am not ready to get a second one just yet just to find that out. Once I have the tank running, I may do that later though.

 

I’m gonna try a keyless remote door lock system. If no one else is using that kind of hardware, I should be safe from frequency interference.

 

Thanks,

Martin

 

-----Original Message-----
From: tanks-admin-at-rctankcombat.com [mailto:tanks-admin-at-rctankcombat.com] On Behalf Of sam D'haene
Sent: Saturday, June 02, 2007 9:32 AM
To: tanks-at-rctankcombat.com
Subject: RE: Tank turret wires. [TANKS]

 

hi,
 

That’s very easy,

First you have to buy a second receiver, because your have a Spektrum DX-6 or -7, you need the same receiver as your first one, witch use the same channel (one of the 80) in the 2.4 band.

 

I’ve got a 35 MHz transmitter, with 2 35 MHz receivers, I only have to use 3 of the same crystals and then it works great. Now I use 35.160. I think that is one of the Advantage to work with crystals.

But before you buy a second one, you have to be sure that its work.

 

If you use 2 Receivers of 6 channels, then you have in total 6 channels!!!

 
sam,

---

From: martin.helsing-at-earthlink.net
To: tanks-at-rctankcombat.com
Subject: RE: Tank turret wires. [TANKS]
Date: Sat, 2 Jun 2007 05:11:49 -0400

How would you do that without a second transmitter if you are using a Spektrum DX-6 or -7?

 

-----Original Message-----
From: tanks-admin-at-rctankcombat.com [mailto:tanks-admin-at-rctankcombat.com] On Behalf Of sam D'haene
Sent: Saturday, June 02, 2007 2:11 AM
To: tanks-at-rctankcombat.com
Subject: RE: Tank turret wires. [TANKS]

 

hi,
 
maybe you can use a second receiver, it's much easier.
 
sam,

---

From: stacyj-at-defnet.com
To: tanks-at-rctankcombat.com
Subject: Tank turret wires. [TANKS]
Date: Sat, 2 Jun 2007 01:33:08 -0400

While suffering several setbacks with my BT-7 chassis,  I've turned my attention to my turret.  While surfing for a cheap slip ring assembly, I found a link to a page showing ball bearings used as electrical contacts.  I immediately thought, what a simple solution to the "turret rotation" problem.  I've liberated four bearings from scrap motors at work and will share my results.

 

---

het ultieme online mailprogramma! Ontdek Windows Live Hotmail,

 

---

het ultieme online mailprogramma! Ontdek Windows Live Hotmail,