Re: Tank T049 Designated [TANKS]

[<sthutch-at-charter.net>]

Chris,
What I have done is drill a hole all the way through the axle shaft (so it is snug 
against the bronze bushing on the tanks outer sidewall) and run a piece of wire 
through it.  However, I think you have a much better idea.  I will give it a try 
this weekend.  Thanks for the idea:-)

Todd

---- OdysseySlipways-at-aol.com wrote: 
> tod, do you have a way of holding the road wheel suspension into the tank  
> yet? i had an idea while looking at the pictures. what about cutting a piece of  
> tubing (pvc?) that would slip over the current shaft that enters the tank and 
>  drill a hole in it for the (spring) bolt to pass through snuggly. this way, 
> the  bolt while hold it all together.
>  
> I like that idea so much, i'll have to do that (once i get that far), but  
> i'll probably just forget as i have about a lot of stuff
>  
> Chris
> _Odyssey  Slipways_ (http://hometown.aol.com/odysseyslipways/index.html)