Re: mold making question? [TANKS]

[OdysseySlipways-at-aol.com]

In a message dated 11/12/2006 11:27:06 P.M. Eastern Standard Time, kjrcartoons-at-yahoo.com.au writes:

1) after making the plug you should coat it in a
sealent.(watered down PVC wood glue is good,)sand when
dry.

2)paint it with auto paint.

3)When happy with the paint job.

4) then I Give three coats of mold wax (not floor wax)

5) then two coats of PVC release.

It should come out clean.

If using the mold more then once you can then cut down
to two wax&one PVC.

Hope this helps

all best Kevin

doing the primer spary and such gets to be a bit much and messy, just get a can of Mann ease release spray

 

Chris,
Odyssey Slipways