[TANKS] trying to figure out rpm's / track speed

[odysseyslipways-at-aol.com]

 okay, i'mgetting outthe paper and catalogs and calculators and and and...

 

anyway, I am a bit stuck on working out the rpm's in one spot............

 

the motor's max rpm is 2600 rpm -at- 24vt

 

motor gear 10 tooth to first gear 36 tooth

second gear 12 tooth (on same shaft as gear one) to axel shaft 36 tooth with a ttrack drive sprocket of 3.9" / 9.906 cm and that will have a cir. of 12.25"/31.12 cm

 

anyone have a easy way to figure this out? just trying to see if i have a decent rpm/speed range

 

-----Original Message-----
From: bill-at-gizmology.net
To: tanks-at-rctankcombat.com
Sent: Sun, 13 Aug 2006 12:23 PM
Subject: Re: Casting parts [TANKS]

This might be helpful: 
 
http://www.gizmology.net/greensand.htm first of several pages about casting aluminum in the back yard 
http://www.gizmology.net/stovetop.htm or casting zinc/aluminum alloy in the kitchen 
 
B. 
 
At 03:27 PM 8/10/2006, you wrote: 
>Anybody out there casting parts in aluminum? 
>I'm thinking about giving it a go, so if you are please share your >experiences. 
> 
>David "any excuse to work on not working on my tank" Cansler 
> 
> 
 
-- 
 
"All cats are possessed of a proud spirit, and the surest way to forfeit the esteem of a cat is to treat him as an inferior being." -- Michael Joseph 
 
 

---

Check out AOL.com today. Breaking news, video search, pictures, email and IM. All on demand. Always Free.