Re: RE: Forget Quicktime, what about CAD [TANKS]

[<adt22-at-drexel.edu>]

Sounds interesting, watch out for the Tyng legal team.  Unfortunately I'm reduced to 
non-milling solutions.  Are you going with the tts2?

Mill-less,
Amir

----- Original Message -----
From: Rick v100 <rickv100-at-yahoo.com>
Date: Friday, April 14, 2006 10:57 am
Subject: Re: RE: Forget Quicktime, what about CAD  [TANKS]

> The Tyng sprocket is the same in cross section as the
> slip joint on a drive shaft. Not that hard to layout.
> I have a graphic on how to mill one out of a tech
> manual. 
> 
> Rick 
> 
> 
> --- adt22-at-drexel.edu wrote:
> 
> > I haven't thought of that, I'll probably either go
> > with wood or smooth-on.  Wood is easy, smooth-on is
> > reproducible.
> > 
> > -Amir
> > 
> > ----- Original Message -----
> > From: Rick v100 <rickv100-at-yahoo.com>
> > Date: Friday, April 14, 2006 10:18 am
> > Subject: Re: RE: Forget Quicktime, what about CAD 
> > [TANKS]
> > 
> > > Any thought to making the TTS sprocket out of
> > either
> > > delrin or ultra-high molecular weight plastic? 
> > > 
> > > You could stack them and gang mill the slots using
> > a
> > > router or mill. 
> > > 
> > > Rick 
> > > 
> > > 
> > > --- adt22-at-drexel.edu wrote:
> > > 
> > > > 
> > > > From: Steve Tyng <STyng-at-acptrust.com>
> > > > 
> > > > > > I think I might give up on the roller
> > sprocket
> > > > idea and go 
> > > > > > with a tts2 for now.  Steve (or Chris), any
> > > > chance of getting 
> > > > > > a printout of the tts2 hub? 
> > > > > 
> > > > > Amir, if you wish to become a licensed
> > > > manufacturer of Tyng Tech 
> > > > > systemsand technology contact me off list to
> > > > discuss.
> > > > 
> > > > Boo! Thats the Window(R) in you talking.  Open
> > > > source it! ;-)  
> > > > 
> > > > We'll see, I might just reinvent the wheel :-)
> > > > 
> > > > -Amir
> > > > 
> > > > 
> > > 
> > > 
> > 
> > 
> 
>