[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
From: |
"chris barthelson" <barthelson88-at-hotmail.com> |
Subject: |
RE: Cutting and drilling plexiglass/acrylic [TANKS] |
Date: |
Mon, 03 Oct 2005 20:33:42 +0930 |
Reply-To: |
tanks-at-rctankcombat.com |
>if possible use a drill press, set your drill to the highest speed the bit
>is rated for. put it through the plexi very slowly and pour water on it as
>you go(put a towel on the floor).
Till now i've been using my Dremel, I just set it to 10,000-15,000 RPM and
use it to "melt" through this works great for small holes but anything over
1/4" doesn't fit in my dremel. Is it posible to use a router to cut shapes
out???
Chris. b
_________________________________________________________________
Sell your car for $9 on carpoint.com.au
http://www.carpoint.com.au/sellyourcar