[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
From: |
Joe Sommer <anvilus9-at-adelphia.net> |
Subject: |
Re: Transmitter question [TANKS] |
Date: |
Wed, 04 May 2005 06:46:25 -0400 |
Reply-To: |
tanks-at-rctankcombat.com |
At 06:22 PM 5/2/2005 -0400, Will Montgomery <wsmontg5-at-netscape.net> wrote:
>>What radio TX and RX are you using? futaba
>>
>>Does the Anvilus controller reduce servo travel
>>or speed on channels 5-6 when it is ON compared
>>to when it is not connected?
>>Yes
Will,
How much travel is reduced - small, medium, large?
How much speed is reduced - small, medium, large?
At 11:48 PM 5/2/2005 +0200, "Marc en Wendy" <marcmethorst-at-zonnet.nl> wrote:
>I'm using a Sanwa Airtronics VG6000 transmitter and Sanwa RX611 receiver.
>The servo travel and speed are the same in both situations.
>
>It's just: channel #5 and #6 don't respond when the controller is switched
>off. The servo trims a bit when you plug it into the receiver but I think
>that only means that the power connection is OK, so that also indicates
>that the signal feed is disturbed.
I can understand why all channels would
be affected but not just #5 and #6.
I will continue to see if I can learn why.
Joe
**********************************************
Joe Sommer, Anvilus Machine Works
2378 Nantucket Circle, State College, PA 16803
814.234.4773 anvilus9-at-adelphia.net
http://www.anvilus.com