Re: Transmission Help [TANKS]

[JOHN PITTELLI <jplily-at-yahoo.com>]

--- Joe Sommer <anvilus9-at-adelphia.net> wrote:

> 
> >> > 
> >Second, what's a good source for v-belt pulleys
> with 1/2 inch diameter
> >shafts that are keyed? I checked the local
> Grainger's and on-line with
> >McMaster-Carr but all their 1/2 inch diameter shaft
> pulleys are keyless.
> 
> If you cannot find 1/2 inch bore pulleys with key
> ways,
> check if your local machine shop has a broaching
> machine.
> It is pretty quick and cheap to cut standard 1/8
> inch key
> ways in pulleys.
> 
>Or, drill and tap for a 1/4 20 set screw and make a
really nice flat spot on the axle. I never had any
trouble with that set up on the original PzIV, even
after I upgraded from KCM to the EV's.

John 
> 
> **********************************************
> Joe Sommer, Anvilus Machine Works
> 2378 Nantucket Circle, State College, PA 16803
> 814.234.4773     anvilus9-at-adelphia.net
> http://www.anvilus.com
> 
> 
> 



        
                
__________________________________ 
Celebrate Yahoo!'s 10th Birthday! 
Yahoo! Netrospective: 100 Moments of the Web 
http://birthday.yahoo.com/netrospective/