RE: wooden drive pulleys [TANKS]

[Rick v100 <rickv100-at-yahoo.com>]

Steve, 

What are you using for an arbor? 

Rick 

--- Steve Tyng <SteveT44-at-comcast.net> wrote:

> Rick wrote:
> 
> > Can you send a pic of the jig for making dished
> road
> > wheels? I have an idea for another vehicle and
> wanted
> > to do the same.
> 
> Here you go.
> 
> The jig was clamped to the table at the one end
> only.  This was the pivot
> point for lowering and raising the piece.  I would
> raise and lower the jig
> while turning the wheel to hog out the wood.  Then
> you finish up by spinning
> the piece around while the jig is held down.  After
> cutting all ten wheels I
> did a finish cut by raising the blade a 1/16" (1mm).
> 
> 
>    Steve
> 

> ATTACHMENT part 2 image/jpeg name=DishJig1.jpg


> ATTACHMENT part 3 image/jpeg name=DishJig2.jpg


> ATTACHMENT part 4 image/jpeg name=DishJig3.jpg




                
__________________________________ 
Do you Yahoo!? 
Yahoo! Mail - Find what you need with new enhanced search.
http://info.mail.yahoo.com/mail_250