Re: Ev's & Sprokets

[adt22-at-drexel.edu]

For some reason, when I was looking for a metric to  inch bushing it was hard to 
find, but hopefully this is useful for you.    Its easier than drilling out anything 
if you already haven't done it:
McMaster part 57485K67
I use two per shaft as they are not that wide.

----- Original Message -----
From: Jim Neifert <jneifert-at-shaw.ca>
Date: Tuesday, October 5, 2004 8:20 am
Subject: Re: Ev's & Sprokets

> I have used a bushing to install with. I pinned the bushing to the 
> EV shaft 
> using a spring pin, then drilled the bushing out so a set screw on 
> the 10 
> tooth sproket goes through the bushing and againest the EV shaft.
> 
> Jim
> Abbotsford, BC
> ----- Original Message ----- 
> From: "chris barthelson" <barthelson88-at-hotmail.com>
> To: <tanks-at-rctankcombat.com>
> Sent: Monday, October 04, 2004 6:15 PM
> Subject: Ev's & Sprokets
> 
> 
> > Hi all
> > to all the people using ev's. How did you attach say a 10 tooth 
> or sproket 
> > in general to an 8mm shaft??? did you go with the bushing style 
> attachment 
> > or something more complex???
> > Thanks, chris. b
> >
> > _________________________________________________________________
> > FREE* Month of Movies with FOXTEL Digital: 
> > http://adsfac.net/link.asp?cc=FXT002.7542.0
> >
> > 
> 
> 
>