[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Wow, thats what Marc suggested as well, I guess its the only way.
I guess drilling a 12mm hole in a piece of round material with 35mm
diameter, then drilling a hole through wheel, round material and axle and
lodging it with a pin is the way to go.
> Can you span the hole with a square piece of metal and drill the metal
> to fit your existing bearings?
>
>
>
> RE:
> There must be an easier way!
>
>
>>> > > Should I just poor it full of Ressin and drill a new
>>> > hole?!
>>> >
>
>
>