[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Bryan, I'm planning on using this monster 24V pull solenoid I purchased from Jameco
electronics. Here's the link to the part,
http://www.jameco.com/cgi-bin/ncommerce3/ProductDisplay?prmenbr=91&prrfnbr=3332&cgrfnbr=501&ctgys=
It's going to be fired using the following RC relay based switch,
http://www.capable.on.ca/rcstuff/onoff.htm
I've purchased enough parts to build ten of these switches. If the first one works
out OK I could build some for others for minimal cost. Of course, a servo
activating a switch will work fine also. That's what all the warship guys using
solenoid valves do.
Steve, T5
-----Original Message-----
From: tanks-at-rctankcombat.com [mailto:tanks-at-rctankcombat.com]
Sent: Monday, December 02, 2002 6:45 AM
To: tanks-at-rctankcombat.com
Cc: stevet-at-stcharlesmd.com
Subject: trigger pull
hey guys
what are you guys useing for trigger pull? are you useing just a servo, what is
the ROF with a servo. any one useing other then a servo.
thx
Bryan Boucher